A4 Sedan V6-3.2L (BKH) (2007)
/Page-3250004.png)
‹› Make sure that washers are seated correctly.
-
Bonded rubber bushings can only be turned to a limited extent. Only tighten threaded connections at control arms if vehicle is in curb weight
position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures/Front
Suspension/Wheel Bearing, Lifting to Curb Weight Position.
-
Insert suspension strut forked head into the control arm and tighten the threaded connection - 1 -.
‹› Bolt must be inserted opposite direction of travel.
-
Insert both upper control arm joint pins in wheel bearing housing and bend downward as much as possible using Pliers (T40067 ).
-
Insert new bolt - 2 - and self-locking nut and tighten.