A4 Sedan V6-3.2L (BKH) (2007)
Input Shaft: Adjustments
01J Transmission
Input Shaft Adjusting with Air Gap Determination
‹› Observe general repair information. Refer to => [ General Repair Information ] See: Continuously Variable Transmission/Transaxle/Service and
Repair/Procedures/01J Transmission/General Repair Information.
‹› Rules of cleanliness for working on transmissions. Refer to => [ Clean Working Conditions ] See: Continuously Variable
Transmission/Transaxle/Service Precautions/01J Transmission/Clean Working Conditions.
‹› All components must be cleaned thoroughly before inserting.
Clutch Measurement
‹› The distance - K - of the clutch from the upper contact ring shim on the shaft (Thrust plate contact surface) is determined.
‹› The corrugated spring washer - 1 - is installed under the disc pack to perform measurements.
-
Place the input shaft on the assembly tool (T10219/1).
-
Insert new lower adjustment disc - 1 - of same thickness as the old one in the input shaft cylinder - A -.