Audi Workshop Service and Repair Manuals

Input Shaft: Overhaul
Input Shaft

Input Shaft

Special tools, testers and auxiliary items required

‹› Puller (T40050)

Removing

‹› Observe general repair notes => [ General Repair Information ] See: Continuously Variable Transmission/Transaxle/Service and

Repair/Procedures/01J,0AN Transmission/General Repair Information.

‹› Rules of cleanliness for working on automatic transmissions => [ Clean Working Conditions ] See: Continuously Variable

Transmission/Transaxle/Service Precautions/01J,0AN Transmission/Clean Working Conditions.

‹› Transmission removed and secured vertically to assembly stand => [ Suspending transmission vertically ] See: Continuously Variable

Transmission/Transaxle/Service and Repair/Procedures/01J,0AN Transmission/Transmission, Securing to Engine and Transmission Holder.

-

Drain ATF => [ ATF, Draining for ATF Flush ] See: Continuously Variable Transmission/Transaxle/Fluid - CVT/Service and Repair/01J,0AN
Transmission/ATF, Draining for ATF Flush, pivot transmission in installation position (level).

‹› Transmission must not be turned so that flange points downward.

-

Remove bolts - arrows -.

-

Carefully tap against the input shaft cover with a rubber hammer to loosen it from the seal.

-

Secure Puller (T40050) on transmission input shaft.