A4 Sedan V6-3.2L (BKH) (2007)
‹› When releasing the operating rod, make sure that clutch pedal does not collide with mounting bracket for clutch pedal switch - arrow -. The
mounting bracket could otherwise break off.
‹› The clutch pedal switch (F 36) => [ (Item 6) ] See: Clutch Pedal Assembly/Service and Repair/Pedal Cluster Assembly Overview and clutch pedal
switch (F194 ) => [ (Item 14) ] See: Clutch Pedal Assembly/Service and Repair/Pedal Cluster Assembly Overview. Only install one time so as to
ensure a firm fit in pedal cluster.
-
Apply spark plug connector pliers (VAG 1922 ) in clutch pedal recesses, press on sides of retaining clip => [ (Item 9) Retaining clip ] See: Service
and Repair/Removal and Replacement/Hydraulic System Assembly Overview and detach clutch pedal from master cylinder.
-
Remove retaining clip - 1 - and remove clutch pedal - 2 -.
-
Remove bolts - 3 - and remove master cylinder - 4 -.
Installing
Installation is perform in reverse sequence. Note the following:
-
Install master cylinder - 4 - and tighten bolts - 3 - to 20 Nm.