A4 Sedan V6-3.2L (BKH) (2007)
/Page-1828005.png)
-
If pipe/hose assembly was disconnected at slave cylinder, the clutch system has to be bled after installing slave cylinder. Refer to => [ Clutch
Hydraulic System Bleeding ] See: Service and Repair/Procedures.
CAUTION!
After installing the slave cylinder carefully press the clutch pedal. If you feel an unusually strong resistance when depressing the clutch
pedal, you must not press it down further. The push rod of the slave cylinder is likely to have been guided past the clutch release lever.
The slave cylinder would then be destroyed once pedal force exceeds approximately 300 N.
-
Install selector shaft lever and tighten nut - arrow -.
-
Bolt drive axle (left side) to flange shaft.