A4 Sedan V6-3.2L (BKH) (2007)
‹› Harness connectors - A -, - B - and - C - on the rear side of the control module must engage on the hydraulic control module.
-
Tighten bolts - arrows -.
-
Install the end cover. Refer to => [ End Cover, with Transmission Removed ] See: Service and Repair/Removal and Replacement/01J
Transmission/End Cover, With Transmission Removed.
After connecting the TCM, the following steps must be performed:
‹› Complete coding for a new TCM.
‹› Perform adaptation for TCM.
Use vehicle diagnosis, testing and information system (VAS 5051) for this.
Tightening Specification