A4 Sedan V6-3.2L (BKH) (2007)
/Page-1930001.png)
Seals and Gaskets: Removal and Replacement
Final Drive, Differential
Input shaft seal, replacing - 01J, Continuously Variable Transmission (CVT)
^
If ATF flows out at underside of transmission bell housing, input shaft seal and/or ATF breather pipe may be leaking. Before replacing any parts,
be sure to find actual cause of malfunction.
^
Input shaft seal must be replaced if leaking.
^
ATF breather pipe must be replaced if leaking.
Note:
^
Refer to Rules of cleanliness for working on automatic transmissions.
^
Refer to General repair notes.
Special tools, testers and auxiliary items required
^
Seal remover T40014
^
Thrust piece T40015
Work procedure
^
Transmission removed.
-
Rotate seal ring extractor T40014 by hand into shaft seal until tool has a good hold in the shaft seal. Then tighten puller with an open-end wrench.
-
You can pull out oil seal a short distance by screwing in rear bolt of puller.
