A4 Sedan V6-3.2L (BKH) (2007)
/Page-2048002.png)
-
Remove circlip.
-
Press inner constant velocity joint off drive axle using special tools shown in illustration.
-
Pull inner CV joint boot off drive axle.
Installing inner constant velocity joint
-
Apply sealant (hatched area) onto clean inner surface of cap on CV joint boot Sealant bead: continuous, 2 to 3 mm diameter. Route around inside
of holes - arrow -.
-
Use sealant D 454 300 A2.
-
Push joint boot onto drive axle.
Drive axle, boot and contact surface of cap must be free from grease!
-
Press on joint up to stop.