A4 Sedan V6-3.2L (BKH) (2007)
-
Install universal dial gauge bracket (VW 387) with dial gauge and 30 mm extension.
-
Apply dial gauge extension exactly at center of intersection of ribs on transmission cover - arrow -.
-
Set dial gauge (3 mm measuring range) to "0" with 1 mm preload.
-
Loosen transmission cover bolts and turn pinion shaft several times.
-
If correct shims have been selected the dial gauge will now indicate the following value:
‹› 0.06 to 0.12 mm
-
Tighten transmission cover bolts again to 35 Nm.
-
Take down measuring tools.
-
Turn pinion shaft 5 turns in each direction so that taper roller bearings seat properly.
Determining dimension "e "
‹› Measurement "e" is required to determine the final shim thickness of "S3" and "S4".
-
Set adjustment rings of universal measuring tool (VW 385/1) to the following values: