audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing oil seals for flange shafts > < Renewing input shaft oil seal

A5

Renewing ball bearing and mounting bracket for flange shaft (left-side)
Renewing ball bearing and mounting bracket for flange shaft (left-side)
Special tools and workshop equipment required
   
t  Thrust plate -VW 401-
  W00-0135
t  Thrust plate -VW 402-
  W00-0136
t  Press tool -VW 412-
  W00-0139
t  Tube -VW 516-
–  Remove flange shaft (left-side) → Chapter.
  W00-0364
–  Remove circlip -1- from flange shaft.
  A39-10432
–  Press ball bearing -A- off flange shaft.
  A39-10433
–  Press ball bearing -A- onto flange shaft as far as stop.
l  Place mounting bracket -B- on ball bearing before pressing on bearing.
l  Installation position of mounting bracket: lettering on mounting bracket faces towards flange.
  A39-10434
–  Fit circlip -1- in annular groove on flange shaft.
  A39-10432

Renewing oil seals for flange shafts > < Renewing input shaft oil seal