A5
| Removing and installing centre differential housing and centre differential |
Note| Removal is also possible with gearbox installed in vehicle → 6-speed manual gearbox 0B4, four-wheel drive; Rep. Gr.34. |
| 1 - | Bolt |
| q | 24 Nm |
| q | Steel bolts (M8; 63 mm long) |
| q | 2x |
| 2 - | Centre differential housing |
| q | With or without vibration damper, depending on design |
| q | Removing and installing → Chapter |
| q | Servicing → Chapter |
| 3 - | Bolt |
| q | 10 Nm and then turn 90° further |
| q | Aluminium bolts (M8; 42 mm long) |
| q | 11x |
| q | Always renew |
| 4 - | Spring |
| 5 - | Dished spring |
| q | Installation position: Inner diameter (convex side) faces centre differential housing |
| 6 - | Shim |
| q | Adjusts preload of ball bearings for centre differential |
| q | Determining thickness → Chapter |
| 7 - | Centre differential |
| q | Can only be serviced by manufacturer |
| q | Servicing bearings for centre differential → Chapter |
| 8 - | Spacer sleeve |
| 9 - | Bearing plate |
| q | Note correct installation position in relation to gearbox cover → Anchor |
| 10 - | Spur gear drive input gear |
| 11 - | Gearbox cover / gearbox |
