audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Pistons and conrods > < Pulling spur gear off crankshaft and shrink-fitting new spur gear

A5

Removing and installing needle bearing in drive plate - vehicles with manual gearbox
Removing and installing needle bearing in drive plate - vehicles with manual gearbox
Special tools and workshop equipment required
   
t  Tube -VW 418 A-
  W00-0367
t  Tube -VW 421-
  W00-0039
t  Support -40 - 103-
  W00-0021
Procedure
l  Gearbox removed.
–  Remove drive plate → Chapter.
–  Place support -40 - 103- under drive plate when pressing out and pressing in needle bearing.
–  Use tube -VW 421- and workshop press and press out needle bearing.
l  Smaller diameter of tube -VW 421- faces drive plate.
  A13-10505
–  Carefully press in needle bearing as far as stop, using tube -VW 418 A- and workshop press.
l  Installation position: closed side of needle bearing faces engine.
–  Install drive plate → Chapter.
  A13-10506

Pistons and conrods > < Pulling spur gear off crankshaft and shrink-fitting new spur gear