audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking valve guides > < Renewing valve stem oil seals with cylinder head removed

A5

Valve dimensions
Valve dimensions
  Note
   
Inlet and exhaust valves must not be machined. Only grinding-in is permitted.
  A15-0326
DimensionInlet valveExhaust valve
Ø amm33.85 ± 0.1028.0 ± 0.1
Ø bmm5.98 ± 0.015.96 ± 0.01
cmm104.0 ± 0.2101.9 ± 0.2
α∠°4545

  WARNING
t  Care must be taken when disposing of old sodium-cooled exhaust valves.
t  The valves must be sawn in two with a metal saw between the centre of the stem and valve head. When doing so, the valves must not come into contact with water. After preparing the valves, throw a maximum of ten into a bucket of water. Then step away immediately, since a chemical reaction will occur in which the sodium filling burns.
t  After performing these steps the valves can be disposed of in the normal way.
   

Checking valve guides > < Renewing valve stem oil seals with cylinder head removed