audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Checking combination valves for secondary air system for correct operation and leakage > < Secondary air system
Secondary air system - exploded view
   
Secondary air system - exploded view
1 - Nut
q   9 Nm
2 - Bonded rubber mounting
3 - Secondary air pump motor -V101-
q   Removing and installing → Chapter
q   Clip electrical connector into bracket
q   Checking in Guided Fault Finding → Vehicle diagnostic tester
4 - O-rings
q   Renew
5 - Secondary air hose
6 - Clip
7 - O-ring
q   Renew
8 - Gasket
q   Renew
9 - Bolts
q   9 Nm
10 - Vacuum hose
11 - Combination valve for secondary air system (right-side)
q   Checking → Chapter
q   Removing and installing → Chapter
12 - Bolt
q   9 Nm
13 - Sender 1 for secondary air pressure -G609-
q   Only on USA models
q   Removing and installing → Chapter
14 - O-ring
q   Renew
15 - Secondary air hose
16 - Bolt
q   9 Nm
17 - Combination valve for secondary air system (left-side)
q   Checking → Chapter
q   Removing and installing → Chapter
18 - Vacuum hose
19 - Bolts
q   9 Nm
20 - Gasket
q   Renew
21 - Bolt
q   9 Nm
22 - Bracket
q   For secondary air hose
23 - O-ring
q   Renew
24 - Secondary air hose
25 - Bracket
q   For secondary air pump motor -V101-
26 - Bolt
q   9 Nm

   
Heat shield for combination valve for secondary air system - tightening torque
–  Tighten bolts -arrows- for heat shield -1- to 9 Nm.
  A26-10585

Checking combination valves for secondary air system for correct operation and leakage > < Secondary air system