Audi Workshop Service and Repair Manuals

Renewing crankshaft oil seal (gearbox end) Special tools and workshop equipment required

t  Fitting tool -T10122-

t  Extractor tool -T20143/2-

Procedure l  Gearbox removed. –  Remove drive plate → Chapter. –  Pry out oil seal using extractor tool -T20143/2-.

–  Modify assembly sleeve -T10122/2- by drilling an 8 mm Ø hole -arrow 2- for the dowel sleeve; use hole -arrow 1- in washer as a drilling template.

–  Clean contact surface and sealing surface. –  Fit assembly aid -T10122/1- onto assembly sleeve -T10122/2- and slide oil seal -A- onto assembly sleeve. –  Detach assembly aid.

–  Fit assembly sleeve with oil seal -1- onto crankshaft.

–  Press in oil seal uniformly until flush all round using press sleeve -T10122/3-. –  Install drive plate → Chapter.