audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exhaust turbocharger, G-charger > < Removing and installing map-controlled engine cooling system thermostatF265

A5

Removing and installing coolant temperature senderG62
Removing and installing coolant temperature sender -G62-
   
Removing
l  Engine cold.
–  Open filler cap on coolant expansion tank briefly and allow residual pressure in cooling system to dissipate.
  A19-10535
–  Remove engine cover panel -arrows-.
  A10-11504
–  Unplug electrical connector -2-.
–  Unscrew bolt -1- and pull off coolant temperature sender -G62-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Coolant temperature senders - exploded view“
  Note
t  Fit new O-rings.
t  To avoid loss of coolant, insert new coolant temperature sender -G62- immediately.
–  Check coolant level → Anchor.
  A19-11145

Exhaust turbocharger, G-charger > < Removing and installing map-controlled engine cooling system thermostatF265