audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Pistons and conrods > < Cylinder block (pulley end)

A5

Renewing crankshaft oil seal (gearbox end)
Renewing crankshaft oil seal (gearbox end)
Special tools and workshop equipment required
   
t  Fitting tool -T10122-
  W00-1234
t  Extractor tool -T20143/2-
  W00-2958
Procedure
l  Gearbox removed → Rep. gr.34.
–  Remove drive plate → Chapter.
–  Pry out oil seal using extractor tool -T20143/2-.
–  Clean contact surface and sealing surface.
  A13-0624
–  Fit assembly aid -T10122/1- onto assembly sleeve -T10122/2- and slide oil seal -A- onto assembly sleeve.
–  Detach assembly aid.
  N13-0782
–  Fit assembly sleeve -T10122/2- with oil seal -1- onto crankshaft.
  A13-0625
–  Drive in oil seal uniformly until flush all round using thrust piece -T10122/3-.
–  Install drive plate → Chapter.
  A13-0626

Pistons and conrods > < Cylinder block (pulley end)