A5
| Lambda probes - overview |
Note| t | New Lambda probes are coated with an assembly paste. |
| t | In the case of a used Lambda probe, coat only the thread with high-temperature paste; refer to → Electronic parts catalogue for high-temperature paste. |
| t | The assembly paste / high-temperature paste must not make contact with the slots on the Lambda probe body. |
| 1 - | Lambda probe 2 after catalytic converter -G131- |
| q | With Lambda probe 2 heater after catalytic converter -Z30- |
| q | Removing and installing → Chapter |
| q | 55 Nm |
| 2 - | Lambda probe 2 -G108- |
| q | With Lambda probe heater 2 -Z28- |
| q | Removing and installing → Chapter |
| q | 55 Nm |
| 3 - | Lambda probe -G39- |
| q | With Lambda probe heater -Z19- |
| q | Removing and installing → Chapter |
| q | 55 Nm |
| 4 - | Lambda probe after catalytic converter -G130- |
| q | With Lambda probe 1 heater after catalytic converter -Z29- |
| q | Removing and installing → Chapter |
| q | 55 Nm |
