audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Fuel delivery unit and fuel gauge sender - vehicles with front-wheel drive > < Fuel tank with attached components - vehicles with four-wheel drive

A5

Removing and installing accelerator pedal module with accelerator position sender
Removing and installing accelerator pedal module with accelerator position sender
   
Removing
–  Remove dash panel trim (bottom) on driver's side → Rep. gr.68.
–  Push release tab -1- upwards -arrow- and unplug electrical connector -2-.
–  Remove bolt -3- and take out accelerator pedal module downwards.
  A20-10380
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Accelerator pedal module - exploded view“
–  Attach accelerator pedal module -4- to bottom of pedal bracket -1-, insert centring pin -2- and tighten bolt -3-.
–  Install dash panel trim (bottom) on driver's side → Rep. gr.68.
–  After renewing, perform kick-down adaption in „Guided Functions“ mode → Vehicle diagnostic tester.
  A20-10432

Fuel delivery unit and fuel gauge sender - vehicles with front-wheel drive > < Fuel tank with attached components - vehicles with four-wheel drive