audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Fuel filter > < Fuel tank with attached components - rest-of-world vehicles with four-wheel drive
Removing and installing accelerator pedal module with accelerator position sender
Removing and installing accelerator pedal module with accelerator position sender
   
Removing
–  Remove dash panel trim (bottom) on driver's side → Rep. gr.68.
–  Push release tab -1- upwards -arrow- and unplug electrical connector -2-.
–  Remove bolt -3- and take out accelerator pedal module downwards.
  A20-10380
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Attach accelerator pedal module -4- to bottom of pedal bracket -1-, insert centring pin -2- and tighten bolt -3-.
–  Install dash panel trim (bottom) on driver's side → Rep. gr.68.
–  After renewing, perform kick-down adaption in Guided Functions mode → Vehicle diagnostic tester.
  A20-10432

Fuel filter > < Fuel tank with attached components - rest-of-world vehicles with four-wheel drive