Audi Workshop Service and Repair Manuals

Removing and installing air filter element Removing

–  Unplug electrical connector -2- at air mass meter -G70-.

–  Release hose clip -3- and detach air hose from air mass meter -G70-. –  Remove bolts -arrows- from air cleaner (top section) and lift out air cleaner (top section).

–  Remove 2 securing bolts -arrows- from air filter element. –  Installing To ensure the proper function of the air mass meter -G70- it is important to observe the following instructions.   Note t  If the air filter element is very dirty or wet, dirt or water could reach the air mass meter -G70- and affect the air mass value. This would lead to loss of power, since a smaller injection quantity is calculated. t  Always use genuine part for air filter element. t  Use a silicone-free lubricant when installing the intake hose. t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue

–  Check water drain hose -arrow- in air cleaner (bottom section) for dirt and other obstructions (clean if necessary). –  Clean salt residue, dirt and leaves out of air cleaner housing (top and bottom sections); use a vacuum cleaner if necessary. –  Check for salt residue, dirt and leaves in air mass meter and air intake hose (engine intake side). –  Check for dirt in air duct leading to air filter element. –  When installing air filter element, check that it is properly centred in retainer in air cleaner (top section).

–  Screw air cleaner (top section) onto new air filter element.

–  Lug on air filter element -1- must make contact with lug on air cleaner housing -2-. –  Fit the top section of the air cleaner carefully on the bottom section, without using force.   Note Before tightening bolts, make sure that top section of air cleaner is inserted into groove on bottom section of air cleaner (to prevent air leaks). –  Then screw top section of air cleaner back onto bottom section. –  Ensure secure fit of air hose at air mass meter -G70-. –  Re-connect electrical connector at air mass meter -G70-. –  The remaining installation steps are carried out in the reverse sequence.