audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing intake manifold flap motorV157 > < Removing and installing intake manifold

A5

Removing and installing throttle valve moduleJ338
Removing and installing throttle valve module -J338-
   
Removing
–  Pull off engine cover panel → Chapter.
–  Release hose clip -3- and detach air hose.
–  Unplug electrical connector -1-.
–  Remove bolts -2- and detach throttle valve module -J338-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter „Intake manifold - exploded view“
  Note
t  Renew gasket.
t  Hose connections and air pipes and hoses must be free of oil and grease before assembly.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
t  To secure the air hoses at their connections, spray rust remover onto the worm thread of the used hose clips before installing.
  A23-10531

Removing and installing intake manifold flap motorV157 > < Removing and installing intake manifold