A5 Quattro Coupe V6-3.2L (CALA) (2009)
Electronic Throttle Actuator: Service and Repair
Accelerator Pedal Module with Throttle Position Sensors
Accelerator Pedal Module with Throttle Position Sensors
Removing
Proceed as follows:
-
Remove driver side lower instrument panel cover.
-
Disconnect electrical connector - 2 - by pressing release - 1 - up - arrow -.
-
Remove bolt - 3 - and remove accelerator pedal module downward.
Installing
‹› Tightening specifications => [ Accelerator Pedal Module Assembly Overview ] See: Accelerator Pedal Module Assembly Overview.
Installation is in reverse order of removal, note the following:
-
Engage accelerator pedal module - 4 - on bottom of pedal bracket - 1 -, insert centering pin - 2 - and tighten bolt - 3 -.