A6 V6-3.0L (AVK) (2004)
/Page-3355002.png)
^
Turn valve body over, and disconnect connector from sensor for transmission RPM -1-.
^
Remove retaining clip (arrow -A-) and unclip wiring harness from retaining clip (arrow -B-).
Installation valid for all:
Installation is the reverse order of removal, noting the following:
^
Connect connectors of wiring harness to respective solenoid valves and sensors when installing.
^
Clip wiring harness into the intended retaining clips. The wiring harness can be pinched during installation in case of variations.
^
Install valve body.
^
Fill up ATF.
