A6 Quattro Sedan V6-3.2L (BKH) (2005)
-
Remove hex nut - 3 -.
-
Remove hex bolt - 4 -.
-
Remove hex bolts - 1 -.
-
Pull stabilizer bar toward rear far enough until hex bolt - 2 - can be removed.
-
Remove coupling rod - 5 -.
-
Remove stabilizer.
If there is not sufficient room to remove stabilizer bar, the following steps must be performed:
-
Support exhaust system at both rear mufflers using wooden block and engine/transmission jack V.A.G 1383 A.
-
Remove hex nuts - 1 - and lower exhaust system.
-
Remove stabilizer.