A6 Quattro Sedan V8-4.2L (BVJ) (2007)
Relay Box: Service and Repair
2-Pin Relay and Fuse Carrier Behind Instrument Panel, Drivers Side, Removing and Installing
2-pin Relay and Fuse Carrier Behind Instrument Panel, Drivers Side, Removing And Installing
Removing
-
With ignition switched off, disconnect battery Ground (GND) wire.
-
Remove lower instrument panel cover on drivers side.
-
Remove bolts - arrows -.
-
Remove relay and fuse carrier - 1 -.
If necessary, proceed with work steps.
-
Unclip fuse holder at relay and fuse carrier.
-
Disconnect relays and unclip respective relay carrier.
NOTE: For the exact assignment of the 2-pin relay and fuse carrier behind instrument panel on drivers side, refer to the current wiring diagram.
Installing
Installation is performed in reverse order of removal, noting the following:
-
Install lower instrument panel cover on drivers side.
-
Connect battery. Required actions.
Tightening torque
Relay and fuse carrier to central tube for instrument panel: 3 Nm