A6 Quattro Wagon V6-2.8L (AFC) (1995)
Fig. 1 Turbulence flap attachment
-
Install turbulence flap retaining assembly (washer, felt ring, and locking clip -A-).
Fig. 2 Aligning flaps in left housing half
-
Using aligning tool -2076 A-, install flaps -A-, -B- and -C-, left to right, as shown.
Note:
On vehicles with automatic climate control, install flap -B- turned 180° (1/2-turn).
Fig. 3 Applying self-adhesive seal to heater core
Heater Core
-
Install seal (as shown) so there are no gaps around perimeter of heater core.
Fig. 4 Sealing heater core outlet (at left housing half)
-
After installing heater core, fill area -A- with silicon rubber sealant (commercially available).