A6 Quattro Wagon V6-2.8L (AFC) (1995)
*For hot climates 50°C
WARNING! Wear safety glasses.
Attach supply reservoir of VAG 1924 ATF filler tool at the highest possible point on vehicle.
Place catch basin under transmission.
After ATF temperature of 35°C is reached, remove ATF check- plug (arrow -1-) and if necessary drain excess fluid.
If ATF leaks out of ATF check-plug hole before ATF has reached 40°C, ATF level is OK.
Note: The ATF check-plug must be reinstalled when ATF temperature reaches 45°C. (For hot climates 50°C)
If at 40°C, ATF does not leak out at ATF check-plug hole, top off ATF using filler hook from VAG1924 ATF filler tool until ATF runs out from ATF
check-plug hole.
Install new seal (arrow) for ATF check-plug.
Install ATF check-plug (60 Nm or 44 ft lb).
Press -> button on VAG1551 scan tool.
Press buttons -0- and -6- to select "End Output" function 06 and press -0- button to confirm input.
ATF, changing and/or topping off after repair
Note:
Observe disposal regulations.
Do not run the engine or tow vehicle without ATF
Place catch basin under transmission.