A6 Quattro Wagon V6-2.8L (AFC) (1995)
-
Secures brake pedal to shaft on pedal bracket
12. Clips
-
For brake light switch -14- and
-
cruise control vacuum vent valves
-
Insert into pedal bracket
13. Vacuum vent valves
-
For cruise control
14. Brake light switch
15. Pin
-
Attaches clevis to clutch pedal
-
Pin may also be installed by turning 180° (easier to insert)
16. Clevis
-
Adjust so that the clutch pedal is positioned approx. 10 mm (0.39 in.) beyond the brake pedal.
-
Make sure that the over-center spring returns the clutch pedal to the rest position, and that the pedal does not contact the pedal bracket. Failure
to meet these requirements will result in premature wear of the clutch lining
CAUTION! If the clevis is correctly adjusted but the clutch pedal does not return properly, check the following possible causes:
-
Air in the clutch hydraulic system
-
Stiffness in the pedal bushing or the over-center spring.
17. Lock nut
-
Tighten after adjusting clevis
18. Clutch master cylinder
19. Screw
-
Master cylinder to pedal bracket
-
20 Nm (15 ft lb)
20. Locking clip
-
Always replace
-
Press onto pin