A6 Quattro Wagon V6-2.8L (AFC) (1995)
-
Remove front crossmember (arrow) below exhaust system.
-
Remove complete exhaust system.
-
Remove heat shields.
-
Remove crossmember below driveshaft.
-
If there are no markings, mark position of flange -A- relative to rear final drive -B- with paint.
-
Loosen driveshaft mounting screws at rear final drive and at automatic transmission.
-
Loosen center bearing mounting bolts.
-
Attach alignment fixture 3298 and tighten plastic nuts.
-
Unscrew driveshaft mounting screws at rear final drive and at automatic transmission.
-
Support driveshaft and alignment fixture and remove center bearing mounting bolts from body.
-
Take out driveshaft and alignment fixture.
CAUTION: Driveshaft must be extended for transporting.
INSTALLATION
-
Install in the reverse order of removal.
NOTE: