A6 Quattro Wagon V6-2.8L (AFC) (1995)
Replace complete CV joint only
Pressing off - Fig. 1
Pressing on - Fig. 2
4. Boot with cap
With vent hole, for CV joint diameters 100 mm (4.0 in) and 108 mm (4.2 in)
Check for cracks and abrasion
Drive off with mandrel
Before assembling, seal with D3 on front side of CV joint
5. Splined shaft
Left and right sides have different lengths
6. CV boot
Check for cracks and abrasion
7. Boot clip
Always replace
Tightening - Fig. 3
8. Circlip
Always replace
When assembling, install in ball hub ring groove
9. CV joint, outer
98 mm (3.9 in) outer diameter
Replace only complete CV joint
Pressing off - Fig. 4
Installing: drive joint on at the shaft with plastic hammer, engage up to circlip
Fig. 1 Pressing off inner CV joint
- Support inner ball hub during this process.
Fig. 2 Pressing on inner joint