A6 Quattro Wagon V6-2.8L (AFC) (1995)
4. Boot with cap
With vent hole
Check for cracks and abrasion
Drive off gently with mandrel
Before assembling, seal with D3 on face of CV joint
5. Splined axle shaft
Different lengths for left and right sides
6. Clamp
Always replace
Tightening - Fig. 3
7. CV boot
Check for cracks and abrasion
Before tightening clamp, ventilate CV boot - Fig. 4
8. Clamp
Always replace
Tightening - Fig. 3
9. Dished washer
Installation position Fig. 6
10. Spacer washer
Installation position - Fig. 6
11. Circlip
Always replace
Installation position - Fig. 6
When assembling, install in ring groove on shaft (not visible when CV joint is installed)
12. CV joint, outer
98 mm (3.9 in) outer diameter
Replace only as complete assembly
Removing - Fig. 5
To install, drive CV joint onto shaft with plastic hammer, engage up to circlip
Fig. 1 Pressing off inner CV joint
Support inner ball hub in this procedure.