A6 Quattro Wagon V6-2.8L (AFC) (1995)
12. Circlip
-
Re-determine thickness when replacing synchronizer hub
-
Location and table: refer to "Procedures"
-
Determining: refer to "Procedures"
13. Operating sleeve for 3rd and 4th gear
-
Installation position: refer to "Procedures"
14. Synchronizer ring for 4th gear
-
Check for wear: refer to "Procedures"
15. 4th gear
-
Insert spring before installing: refer to "Procedures"
16. Needle bearing for 4th gear
17. 5th gear
-
Removing: refer to "Procedures"
-
Installing: refer to "Procedures"
18. Circlip
-
Re-determine thickness when replacing 5th gear
-
Location and table: refer to "Procedures"
-
Determining: refer to "Procedures"
19. Needle bearing for input shaft
-
Is damaged when removing
-
Always replace
-
Removing: refer to "Procedures" at Controls and Housing/Disassembling and Assembling/Shift Mechanism, Input Shaft, Pinion, Cover
-
Knock with drift VW 295, the adapter tool VW 295a and the tube section VW 416b
-
Installation position: refer to "Procedures" at Controls and Housing/Disassembling and Assembling/Shift Mechanism, Input Shaft, Pinion,
Cover
20. Plastic sleeve
-
Always replace
21. Transmission cover