A6 Quattro Wagon V6-2.8L (AFC) (1995)
Rear Door Window Regulator: Service and Repair
Removing
-
Lower window half-way.
-
Remove door trim panel.
-
Disconnect electrical connector to window regulator motor.
-
Remove door component carrier.
-
Lay component carrier on padded table.
-
Remove regulator mounting screws.
-
While holding glass and regulator in place, turn over carrier.
-
Using small screwdriver push locking clip -1- up and out of notch on bolt -4-.
-
Remove washer -2-.
-
Carefully raise and hold door glass.
-
Remove regulator from securing clip, and pull out from bottom.
Installing
Install in reverse order of removal, noting the following:
-
Stick washer (rubber) -3- onto guide bolt -4-.
Apply small amount of grease to secure washer in place when installing.
-
Install regulator from below, and guide onto door glass with guide bolt -4-.
-
Install locking clip -1-.
-
Lightly tighten mounting screws.
-
Turn component carrier over and tighten mounting screws. Tightening torque: 10 Nm (7 ft lb)