A6 Quattro Wagon V6-3.0L (AVK) (2002)
-
Holes -1- and -2- of the carrier and hole -3 of the aluminum bracket must line up on both sides.
Note: Fixing the carrier in this way is a substitute for a subsequent axle alignment only when:
-
If only the carrier has been removed and reinstalled.
-
Holes -1- and -2- lined up before the repair.
-
Start hex bolts-1- and -2-.
-
Start hex nuts -3- and -4-.
-
Protect hole in body for holding special tool 3393 against corrosion.
Tightening sequence/tightening torques
Thread in body can be repaired with thread insert made of wire according to DIN 8140 (Helicoil). Thread insert must have same length as thread in
body.
-
Bonded rubber bushings can only be turned to a limited extent. The bolted connections on the suspension links should therefore only be tightened
when the vehicle is standing on the ground.