A6 Quattro Wagon V6-3.0L (AVK) (2002)
-
Remove mounting bolts (arrows) and swing coolant reservoir aside.
Tightening torque: 6 Nm
-
Remove bolts -1- for hydraulic fluid reservoir and swing to side.
-
Tightening torque: 10 Nm
-
Use rubber grommet to align properly when installing
Note: Cover engine compartment to make sure that brake fluid does not flow into it.
-
Disengage intake hose -1- from hose clamp and remove.
-
Remove brake lines -3- and -4-.
-
Seal brake lines and threaded holes using plugs from repair kit, Part No. 1 HO 698 311 A.
-
Unclip brake lines from bracket.
-
Remove hex-nut -2-.
-
Remove hex-bolt for securing bracket.
-
Raise bracket with hydraulic unit and hydraulic pump approximately 30 mm and remove from engine compartment.
Installing