A6 Quattro Wagon V6-3.0L (AVK) (2002)
High Pressure Sensor / Switch: Service and Repair
High Pressure Sensor -G65-, Removing And Installing
-
Remove front bumper:
-
Disconnect connector -B-.
-
Remove High Pressure Sensor -G65-
Tightening torque: 5 Nm.
-
O-Ring-seal -A- (10.8 mm x 1.8 mm) replace.
NOTE:
-
The illustration shows High Pressure Sensor -G65- on condenser for vehicle with 2.0 L or 3.0 L gas engine, on other condensers the High Pressure
Sensor -G65- is installed on the right hand side.
-
The cooling performance cannot be checked with High Pressure Sensor -G65- the A/C Control Head -E87- does not switch on the compressor.
-
The refrigerant circuit remains closed, connection with valve.
-
Checking function and delivered signal of High Pressure Sensor -G65-.