A6 Quattro Wagon V6-3.0L (AVK) (2002)
Air Bag(s) Arming and Disarming: Service and Repair
Deactivation of Rear Side Airbag
Deactivation Of Rear Side Airbag
Deactivating
-
Remove seat bench
NOTE: Side airbags at left and right can only be shut off together. It is not possible to shut off the side airbags individually.
-
There is one harness connector at left and right by the "C-pillar"
-
Press catches - 2 - and disconnect connector - 1 - in direction of arrow.
-
Secure the loose harness connectors with cable ties.
Vehicles without head-level airbag from m.y. 2003
-
Remove rear wheelhousing trim.
-
Disconnect harness connector to crash sensor at C-pillar.
-
Install rear seat bench.
-
Affix sticker for deactivated side airbags
-
Change coding of airbag control module to the code for no rear side airbags.
See Guided Fault-finding, Body, Body Installation, 69 passenger protection, airbag 8.4E, electrical components, Airbag Control Module -J234-, coding
Airbag Control Module -J234-.
-
Fill out registration card and deliver card to the appropriate distributor or importer for registration. Place sheet 3 of the registration card in the
owner information packet for the customer.
Activating
-
Remove seat bench
NOTE: Side airbags at left and right can only be switched on together. It is not possible to switch on the side airbags individually.
-
There is one harness connector at left and right by the "C-pillar"
-
Cut cable ties for harness connectors.
-
Connect harness connectors - 1 - for side airbags.
-
Connect harness connectors - 1 - in cushion cut-out of rear seat bench
-
Remove rear wheelhousing trim.