A6 Quattro Wagon V6-3.0L (AVK) (2002)
-
Turn tap toward filling hose -bottom arrow-. ATF runs into transmission.
-
Hold suitable container under outlet of filling device.
-
Check ATF level by turning tap toward outlet bottom arrow-.
ATF level is correct if only a small amount ATF drips out of outlet before 45°C is read
Note:
Approx. 5 cl of ATF from the inner oil level pipe always discharged initially.
-
If no further ATF is discharged, turn tap bad toward filling hose and pour in more ATF; check ATF level again.
-
Remove tap when correct ATF level has been reached.
Note: A few drops of ATF will be discharged when tap is removed.
-
Replace ATF check plug.
-
ATF check plug -B- must be closed again by 45°C (For hot countries 50°C) at the latest.
-
Tightening torque: 20 Nm
Note:
If the ATF temperature exceeds 45°C, too much ATF will be discharged as a result of the rise in temperature and the transmission will not be
sufficiently filled!
-
Quit "08 - Reading measured value block" function by touching <- key.
-
Select "06 - End Output".
-
Switch off ignition and disconnect diagnostic cable.
ATF, changing and topping up after repair work