A6 Quattro Wagon V6-3.0L (AVK) (2002)
-
Insert determined adjustment shim -1 and swing bracket for intermediate bearing -2- to other side.
-
Place second adjustment shim -4 on to stud -3-.
-
Now tighten both plastic nuts of installation device -arrow A- again.
Centering drive shaft lengthwise
-
Slide drive shaft with alignment fixture toward rear to stop.
-
Mark location of intermediate bearing to assembly (arrow -A-)
-
Slide drive shaft with alignment fixture toward front to stop.
-
Mark location of intermediate bearing to assembly (arrow-B-)
-
Center drive shaft (arrow C):
-
Intermediate bearing must be centered between markings A and B.
-
Tighten intermediate bearing in centered position to 25 Nm (arrow C).
-
Then remove mounting fixture.
Installation is reverse of removal, noting the following:
-
Install exhaust system free of stress.