A6 Sedan V6-2.8L (AHA) (1998)
Seat Padding: Service and Repair
Seat Cushion
Seat cushion, removing and installing
1
-
Seat cushion
Removing
-
Move seat fully up.
-
Remove seat.
-
Remove seat cushion extension, front cover panel and guide sleeves.
-
Remove mounting trim pieces.
-
Remove spring cover.
-
Detach electrical cover -2- under seat.
-
If installed, disconnect seat cushion wiring (seat heater, seat occupied sensor).
-
Push up front of seat cushion -1-.
-
Remove seat cushion -1- forward and out.
NOTE: Both seat springs and their related rubber buffers located in the rear between seat cushion and backrest fall out by themselves.
Installing
-
Make sure that rubber buffers -3- are correctly located in the mounts on the backrest.
-
Install springs -4- in seat cushion.
-
Insert electrical cover -2- between backrest and seat frame.
-
Install seat cushion -1- so that springs -4- sit on rubber buffers -3- at backrest.
-
Push seat cushion -1- toward rear.
-
Push down on front of seat cushion -1-.
-
If necessary, attach wiring in seat cushion.
-
Install electrical cover beneath seat.
2
-
Electrical cover
3
-
Rubber buffers (2x)
4
-
Springs (2x)