A6 Sedan V6-2.8L (AHA) (1998)
If resistance is not as specified:
-
Replace solenoid valve.
Checking voltage supply of valves for camshaft adjustment
-
Disconnect harness connector from valve.
-
Connect LED tester VAG 1527 between engine ground and terminal 1 of connector (B+).
-
Crank starter for several seconds (engine can start).
LED in voltage tester must light up.
If LED does not light up, conduct the following tests:
-
Check fuse for valves for camshaft adjustment.
-
Check wiring from terminal 1 on 2-pin connector to fuse for continuity per wiring diagram.
-
Check fuel pump relay and signal to relay.
Checking signal to valves for camshaft adjustment
-
Disconnect harness connector from valve.
-
Connect LED tester VAG 1527 between connector terminals 1 and 2.
-
Check using output DTM and activate camshaft adjustment
LED must flash.
If LED does not flash or stays on continuously:
-
Connect VAG 1598/22 test box to Motronic ECM harness connector and proceed as follows:
If LED does not flash:
-
Check wiring from terminal 2 of connector for valve to terminal 55 of ECM/test box for continuity and short circuit to B+.
If LED stays lit constantly: