A6 Sedan V6-2.8L (AHA) (1998)
Power Seat Control Module: All Technical Service Bulletins
Work Procedure
Section A - Check Seat Control Module Version
^
Connect VAG 1551 to vehicle and press button -1- to select "Rapid data transfer"
^
Press buttons -3- and -6- to check seat memory
^
Press -Q- button to confirm
^
Check seat memory control module version indicated on the display. Software version must be at least D05
^
If software version is correct, exit program and remove VAG 1551 as no other work is required
^
If software version is not correct, remove VAG 1551
Proceed to Section B
Section B - Install Seat Control Module
^
Move drivers seat to highest and most rearward position
^
Remove screw -1- at the front of the right side seat trim -4- of driver's seat
^
Remove screw -2- at the rear of the left side seat trim -3-
^
Raise rear of left seat trim, slide forward and remove from seat to expose seat memory control -5- and wire harnesses
^
Disconnect T6P connector (red) located under right front corner of driver's seat