A6 Sedan V6-2.8L (AHA) (1998)
^
Disconnect (2) electrical connectors at -6- and -7- of control module
^
Remove screw -8-
^
Push clip -9- in direction of arrow and remove seat memory control module and return to AoA
^
Install new seat memory control module (4B0 959 760 A version D05) and secure with screw -8- to 1.5 Nm (13 in. lb.)
^
Reinstall (2) electrical connectors into seat control module
^
Reconnect T6P (red) connector under right front corner of driver's seat
^
Reinstall left side seat trim
^
Proceed to Section C
Section C - Set seat memory basic settings in new Seat Control Module
^
Connect VAG 1551 to vehicle and press button -1- to select "Rapid data transfer"
^
Press buttons -3- and -6- for seat memory
^
Press -Q- button to confirm
^
Press --> button
^
Press buttons -0- and -8- to select "Read Measuring Value Block" function 08
^
Press -Q- button to confirm
^
Press buttons -0-, -0- and -2-
^
Press -Q- button to confirm
^
Move drivers seatback fully forward
^
Write down the numerical value shown in the display field 4
Note:
The numerical value shown in this illustration is only an example. Your value may be different.