A6 Sedan V6-2.8L (AHA) (1998)
Shifter A/T: Service and Repair
Selector Lever Handle
REMOVING AND INSTALLING SELECTOR LEVER HANDLE
Removing
-
Move selector lever into position "3."
-
Slide sleeve -1- down as far as it will go.
-
Pull button -2- out of selector lever handle -3- until it clicks (distance -a-) and pull handle upward.
Dimension -a- = 3 mm
Installing
-
Shift selector lever into position "3."
-
Carefully pull button -2- out of selector lever handle -3- to the position indicated by distance -a-.
-
Then,with button -2- pointing toward front of vehicle, fit handle -3- onto selector lever and push down as far as possible.
-
Turn handle -3- until button -2- points toward driver's seat.
The handle will engage in a vertical groove on the selector lever.
-
Push handle -3- down fully so that it engages in circular groove on selector lever.
-
Press button -2- into handle on selector lever -3-.
-
Pull up sleeve -1- until it engages in selector lever handle -3-.