A6 Sedan V6-2.8L (AHA) (1998)
/Page-5506001.png)
Wiring Harness: Service and Repair
5 Speed Automatic 01V
Wiring Harness in Transmission, removing and installing
Removing
-
Remove valve body.
-
Using a small screwdriver, pry out retaining tabs on solenoid valve connector and pull off harness connectors -A- one after the other.
-
Disengage wiring harness from retainers -B- on side of valve body.
Only for transmissions with hydraulic control E17
-
Turn valve body over, and disconnect connector from sensor for transmission RPM -1 -.
-
Remove retaining clip (arrow-A-) and unclip wiring harness from retaining clip (arrow -B-).
-
Disconnect connector -2- from solenoid valve 4 -N91-.
Only for transmissions with hydraulic control E18/2
-
Turn valve body over, and disconnect connector from sensor for transmission RPM -1 -.
-
Remove retaining clip (arrow-A-) and unclip wiring harness from retaining clip (arrow -B-).
Installation valid for all:
Installation is the reverse order of removal, noting the following:
