A6 Sedan V6-2.8L (ATQ) (2000)
-
Unbolt outer seat-belt attachment point.
-
On vehicles with automatic transmission, remove locking cable at lever bracket
-
Remove air ducts at center console.
-
Remove air ducts at center section of instrument panel.
-
Detach wiring for rear vents at tunnel and attach wiring to instrument panel (or steering wheel).
-
Pull parking brake up as far as it will go.
-
Move gear shift/selector lever as far back as possible.
-
Detach floor covering from seat rail and rear footwell vent.
-
Pull out floor covering beneath lower C-pillar trim.
-
Lift rear section of floor covering over parking brake lever.
-
Pull floor covering over bracket in front of airbag control module.
-
Pull floor covering backward and lift over gear shift/selector lever.
-
Fold floor covering lengthwise and remove through door.
Installing
-
Fold new floor covering lengthwise and place in vehicle.
NOTE: Floor covering is likely to tear at cut-outs.
-
Push floor covering forward as far as it will go until hole patterns for accelerator pedal stop and foot rest are aligned.
-
Press floor covering under parking brake lever.
-
Carry out remainder of installation in reverse order of removal.