A6 Sedan V6-2.8L (ATQ) (2000)
When indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.
When indicated on display:
Read Measuring Value Block
Q
Input display group number XXX
-
Press buttons -0-, -6- and -2- to select "display group number 062" and press -Q- button to confirm input.
Indicated on display:
Read Measuring Value Block 62
->
1
2
3
4
-
Check specified values for E-gas potentiometer voltages in display fields 3 and 4.
NOTE: Engine Control Module (ECM) calculates the voltage values of the angle sensors in percent relative to 5 volts and displays these percentage
values. (5 volts supply voltage represents 100%).
-
Observe display field 3 and 4.
-
Slowly depress accelerator pedal completely.
Percent indication in display field 3 must rise uniformly. The tolerance range 12 to 97% is not used completely during this.
Percent indication in display field 4 must also rise uniformly. In the process, the tolerance range of 4 to 49% is not completely utilized.
NOTE: The indicated value in display field 3 must always be about twice as large as the value in display field 4.
If indications do not resemble description:
-
Check voltage supply and wire connections of sensor for accelerator pedal position.
Checking Voltage Supply Of Throttle Position (TP) Sensor
-
Remove driver-side storage compartment.
-
Disconnect harness connector for accelerator pedal position sensor.
-
Switch ignition on.