A6 Sedan V6-2.8L (ATQ) (2000)
Control Module: Service and Repair
Removing and Installing
Removing
-
Remove lower section of A-pillar trim (right-side) and sill moulding at right-front door.
-
Detach carpeting from inside of sill (right-side) below front door, and raise carpeting approx. 20 cm (8 inch).
-
Unclip box at -A- by pulling it upward.
-
Unclip box at -B- as shown.
-
Unclip TCM from box (arrows).
-
Release catch on multi-pin connector and disconnect connector from TCM refer to Fig. 3.
Installing
Installation is the reverse of removal, with the following additional steps:
-
Check that clip -1- is properly secured.
-
Switch ignition off and wait approx. 30 seconds.
-
Release connector by pressing catch in direction of arrow.
Installation is the reverse of removal.