A6 Sedan V6-2.8L (ATQ) (2000)
-
VAG1459 B/2 supplementary kit
-
Kukko 17/2 separator
-
Bell E-40
-
Pressure piece E-43
-
Pressure sleeve E-44-1
-
Pressure piece E-45
-
Loosen hex bolt for drive axle when vehicle is standing on its wheels (risk of accident).
-
Remove wheel and raise vehicle.
-
Pull cable of ABS wheel speed sensor out of bracket on brake caliper.
-
Pull ABS wheel speed sensor out of wheel bearing housing.
-
Remove adapter with brake caliper and hang on body with tie wire.
-
Remove brake disc and backing plate.
-
Remove nut-1- and hex bolt, and lift out both control arms -2-.
-
Slits in wheel bearing housing may not be widened with a chisel or similar tool!
-
Unscrew hex bolt for drive axle.
-
Swing out wheel bearing housing.
-
Take drive axle out of wheel bearing housing and tie up.
Note: Place VAG13831A transmission lifter underneath (danger of accident if parts fall off when ejecting wheel hub and wheel bearing).
Pulling out wheel hub